STATE-OF-THE-ART SYSTEM AVAILABLE TODAY

FEATURES:

• Much stronger electrode assembly both in material and construction technique.
• Fixed side electrode is rigid and will stay in alignment with the rest of the fingerjoint equipment.
• Better control of the movable side electrode with a new approach to air control and positioning.
• The electrode system, as built, can be applied to a fixed center line or fixed edge drive system.
• 100 percent aluminum enclosure and aluminum flashing around all steel framework to contain RF and minimize RF interference problems.
• Access to the electrode area is by hinged doors with snap latches.  Switches located on each door can stop the RF, if doors are opened during normal running.
• Beacon lamps mounted on top of each section indicate status of the electrode: RF on, doors open and which side.
• Much easier to access and make tuning changes when changeovers are required.
• Electrode wear strips and guide rails can be serviced or replaced without removing complete electrode assembly.
• Unique lower lumber support allowing electrodes to be opened 1 1/2" to 2" wider than normal during loading, unloading and servicing without dropping the lumber out of line.
• The electrode will open to a full 14", allowing for much easier cleaning and maintenance.
• Unique lower lumber support allowing electrodes to be opened 1 1/2" to 2" wider than normal during loading/unloading/servicing without dropping the lumber out of line.
• Easy to clean; the electrode will open to a full 14" allowing for much easier cleaning and maintenance.