Charging Bar
Our new cantilevered charging bar system is designed to work with any existing horizontal type batch press. It also complements our new side transfer sweep system. This combination allows for a press automatic infeed system that does not take up a lot of space, width wise.
Table portion of the charger is made with one piece of steel, up to 20 feet, and thick enough to insure a flat working surface.
The charging arm is designed with throat on the fixed, straight edge side, so caul or spacer can be attached on the table and the charging will clear.
The extension bars used to reach up to
or sight by in the electrode are easily adjustable in width and accommodate
different load widths.
General Specifications:
-
Width = Maximum opening of press +4"
-
Length = Maximum material length +72"
-
Lumber line height = by customer
-
Working push load = up to 1000 lbs.
-
Bar position can be controlled by encoder or limit switches
-
Drive variability via VFD drive
-
Power requirements: 480 VAC 3 phase with 15 amp disconnect